Receive instant hot water with this gas water heater at a rate of 10 litres per minute. Heat water 25 degrees above ambient temperature at the full 10LPM (higher temperatures can be achieved with smaller flow rates). A simple design with automatic ignition means the heater is activated when the tap is turned on and switches off when the tap is turned off - without using a pilot light. Built-in safety features include a flame failure device and low water pressure cut out.
This appliance must be installed by a registered gasfitter in accordance with AS/NZS 5601 and NZS 5428
- Dimensions (H x W x D) : 636 x 350 x 238mm (top vent excluded)
- 1/2'' threaded water inlet and outlets
- 1/2'' threaded gas inlet (hosetail with rubber washer supplied)
- Recommended pressure: 35-55PSI
- Recommended flow: 10-15LPM
- Steel housing, white enamel finish
- LCD temperature display
- Ignition uses 2 x D cell batteries (sold separately) so no external power required (designed for use with energizer batteries)
- Achieves 25 degrees increase at 10 lpm (or higher at lower flow rates)
- Automatic ignition - no pilot light (starts when tap is turned on, stops when tap is turned off)
- Flame failure (gas shuts off if flame goes out)
- Low water pressure cut out
- Gas hose and regulator not included
- THIS UNIT MUST BE VENTED EXTERNALLY SO WE RECOMMEND SEEKING ADVICE FROM YOUR GASFITTER REGARDING THE INTENDED MOUNTING LOCATION AND VENTING OPTIONS
Delivery estimate 1-4 business days
$5.99 standard freight rate for non-rural, shoe box sized deliveries. Additional charges apply for rural delivery, island delivery, dangerous goods and large packages.
Returns
Check out our easy returns policy.
Product Questions
Can you supply a flue kit/ chimney cap for this appliance?
Question by: Adrian on 22/07/2021, 4:52 pm
As these Water Heater can ONLY be installed by licensed Gas Fitters - the Gas Fitters will know where to get the Flue Kits from.
Answer by: Website Customer Service (WE) on 23/07/2021, 8:23 am
