Gas Water Heater 10LPM

UPC: 34431

Gas Water Heater 10LPM

Instantaneous gas water heater that will provide on demand hot water at the rate of 10L per minute. Simple and reliable design that is suitable for many applications where hot water is required.
  • Achieves 25 degrees increase at 10 lpm (or higher at lower flow rates)
  • Automatic ignition - no pilot light (starts when tap is turned on, stops when tap is turned off)
  • LCD temperature display
  • Flame failure (gas shuts off if flame goes out)
  • Low water pressure cut out
  • Battery ignition (uses 2 x D cells) so no external power required (designed for use with energizer batteries)
  • Steel housing, white enamel finish
  • 1/2'' threaded water inlet and outlets
  • 1/2'' threaded gas inlet (hosetail with rubber washer supplied)
  • Recommended pressure: 35-55PSI
  • Recommended flow: 10-15LPM
  • Gas hose and regulator not included
  • This unit must be vented externally so we recommend seeking advice from your gasfitter regarding the intended mounting location
  • This appliance must be installed by a registered gasfitter in accordance with AS/NZS 5601 and NZS 5428
  • Dimensions (H x W x D) : 636 x 350 x 238mm (top vent excluded)



Water Heater 10L White Enamel Burnsco

Price $549.99

Or 4 fortnight payments from $137.50 with what's this?
2-5 days


Write your review
Work Wonderful
Sun Apr 8, 2018

Great only just got gas installed to put it on pur cabin works wonderful thanks burns co

Was this review helpful to you? Login to rate this review
A Great Little Water Heater.
Fri Oct 3, 2014

Very prompt delivery and just as it was described over the phone.

Was this review helpful to you? Login to rate this review 1 out of 1 person found this review helpful.