Hi, I am looking to clean and refresh my fiberglass gelcoat on my yacht. Will the Grunt range be ok to use on the non slip sections of the deck as well. Regards Dave
Question by: Dave Capamagian on 26 Aug 2024, 10:00 pm
Hi Dave, yes should be alright with regards to cleaning the oxidation on flat fibreglass surfaces and if the non slip sections are moulded into the fibreglass - only is not suitable for aluminium. If you have like a textured/grit non slip surface over the fibreglass, similar to a 'Kiwigrip' which has algae/mildew growth then you may be better off to scrub with a soapy water solution to remove.
Answer by: Website Customer Service (JW) (Admin) on 27 Aug 2024, 8:51 am
Hi there would this remove old fish blood stains from weathered gelgoat? Also just to confirm does this remove the old powdered gelgoat layer? thank you
Question by: Derek on 6 May 2025, 11:41 am
Emergel is good for removing oxidation from gelcoat. To remove stubborn blood stains you could try a Vinegar solution.
Answer by: Website Customer Service (JGW) (Admin) on 6 May 2025, 2:14 pm
© Copyright Burnsco 2026
Compare